1).内存插槽变形 

　　这种故障不是很常见，一般见于主板有形变，内存插槽有损坏，裂缝等现象，当我们把内存插入内存插槽时时就会出现部分接触不良的情况，当主机加电开机自检时就不能通过，就会出现连续的短“嘀”声，也就是大家常说的“内存报警”。对于主板形变，内存插槽变形的现象我们可以在内存插好后通过使用尼龙扎带紧固，再辅以打胶的方法来解决此类问题。  (更多精彩内容 请访问电脑知识网www.108sj.com)

　　不过，在拔插内存的过程中我们一定要注意内存的方向，虽然内存条和内存插槽有防呆设计，但是还有有许多菜鸟仍然把内存插反，造成内存条和内存插槽个别引脚烧熔的情况，这时只能放弃使用损坏的内存插槽。对于引脚烧熔的内存条，我们可以仔细检查一下，如果只是77和85接地端烧熔，也或许是其他内存条的接地端，即使把金手指烧得脱落了(PC235.COM编辑:建国 )，这样的内存条因是接地端在反插时把电源正与地短路了，才造成打火烧毁内存条的金手指和内存插槽的引脚，而内存芯片却没有受到任何损伤，所以这样的内存条我们只要把其插在正常的内存插槽上就可以正常使用。 

　　有时我们还要注意内存插中是否有其他异物，因为如果有其他异物在内存插槽里，当插入内存时内存就不能插到底，内存无法安装到位，当然就会出现开机报警现象。当我们多次拔插内存仍不能解决问题时，最好仔细检查一下内存插槽是否变形，是否有引脚变形或损坏，脱落，插槽里是否有异物等情况，这样做对我们排除故障很有帮助。 

　　2).内存金手指氧化 

　　这种情况最容易出现，一般见于使用半年或一年以上的机器。当天气潮湿或天气温度变化较大时，就会出现昨天机器工作还好好的，可第二天早晨开机时即发现无法正常开机，显示器黑屏，只听得机内“嘀嘀“直响。 　　

　　这种情况如果只是偶尔一次也不值得大惊小怪，只要拆开机箱把内存条重插一下就可以了。不过如果这种故障每个月都发生一次或者一个星期或半个月就要出现一次，那就要考虑是不属于内存条与主板兼容性不好的问题了，也就是下面要说的第3种类型的问题。

【以下内容为电脑知识网站提供英文翻译，未经授权请勿转载】

PC235 finishing amended by the chief reprint please specify the source of computer knowledge network:

1). Deformation memory slots

This failure is not very common, the general view of a board deformation, the memory slot of damage, cracks and other phenomena, when we insert the memory of the memory slots from time to time there will be some connection is bad the situation, when the host power when the power-on self test Can not pass on, there will be for the short "Di" sound, that is, we often say that the "memory alarm." The board deformation, deformation of the phenomenon of memory slots in the memory we can properly inserted after Zhadai retention through the use of nylon, supplemented by a plastic way to solve such problems.

However, removable memory in the process of memory we must pay attention to the direction, although the memory and a memory slot Fangdai design, but there are still many rookie into the anti-memory, a memory and memory slots with individual Shaorong the legs, then only to renounce the use of defective memory slots. For the memory of the pin Shaorong, we can double-check, if only 77 and 85 ground-Shaorong, perhaps the memory of the other side of the earth, even to the shedding Goldfinger burned, this is due to the memory of Ground-in anti-inserted when the power is to short-circuit and the only cause of the tinder-burning memory and memory slots Goldfinger-pin, and memory chips have not been any damage, so the memory of our so long as its Inserted in the normal memory slot on the normal use.
(More exciting content please visit the network computer knowledge www.108sj.com)
Sometimes we would also like to note in memory into whether there are other foreign body, because if there are other foreign body in memory slot, insert the memory when the memory can not be inserted in the end, the memory can not be installed in place, of course, there will be start-up alarm phenomenon. When we repeatedly plugged memory does not resolve the problem, it is best to check carefully whether the deformation of memory slots, whether there is a pin deformation or damage, loss, slots, such as whether there is a foreign body, it is our troubleshooting Helpful.

2). Goldfinger memory of

The most vulnerable to this situation, the general view of the use of six months or a year or more machines. When the weather is humid weather or temperature changes larger, there will be also good work machines yesterday, the morning start-up that is not found the boot, displays a blank screen, only heard of "Didi" straight ring.

If this situation is not worthy of an occasional surprised, as long as the chassis to break into the memory of the weight on it. But if such failures have taken place in a month or a week or two weeks to occur, it must consider is not a memory of the motherboard and not a question of compatibility, that is to say the following paragraph 3 Types of problems.
总结造成内存与主板接触不良的原因文章结束